1. Prior to assembly, A) If you have already mounted a mechanical deadbolt, please remove and replace it with our smart deadbolt. The installation is drilling-free. B) Check the door's opening direction: If the front panel is fastened on the left, turn the toggle button to the L, and if it is fastened on the right, turn it to the R.
Page 3
2. Parts & Components Layout 4 AA Batteries (Not included) 1"(25.4mm) 5/16"(8mm) 1-1/2"(40mm) 25/32"(20mm) 3/16"(5mm) 1/8"(3mm)
6. Touch-screen installation (Attach the bolt here if you have already drilled a hole. If not, it’s not necessary.) Make sure it fits through this hole in the correct position...
Page 8
7. Back-side assembly 1-1/2"(40mm) x3 (or x 2)
Page 11
10. Access handle 1/8”(3mm) NOTE: if the Pin length is longer than the door thickness, you can cut 1 or more slot away to make the mounting properly. Reference: 10mm Slot numbers Door thickness remain (mm) 55-60 45-50...
Page 12
11. Attach the touchscreen’s wires to the right port...
Page 13
12. Set the toggle button to the right position Toggle L or R Push the toggle to the L/R position according to the door's opening di rection. (As mentioned in step 1.B) If the lock pad (front panel) is fastened on the left, turn the toggle to L, and to R if it is fastened on the right.
Page 14
13. Rear Lock Keep the bolt closed 2) Turn the knob properly - If you turned the toggle to R in step 12, turn the knob clockwise to the end (Fig. 1) - If you turned the toggle to L in step 12, turn the knob counterclockwise to the end (Fig.
Page 15
14. Sensor assembled onto frame *NOTE: The door will lock itself once sensor is activated. Do NOT insert the battery while assembling. Keep the magnet and door sensor parallel and the gap between them as short as possible (less than 20mm). Magnet Door Sensor...
Page 16
15. Strike plate and cover onto frame Drill the hole according to the component’s size and bolt’s position.
Page 17
16. Batteries *NOTE: Do NOT close the door until the App is enabled Install 4 AA batteries and assemble the battery cover...
Page 18
1. What’s the original passcode of deadbolt? The original passcode is 123456, and you can input 123456# on lock keypad to unlock it. Note: Once the lock is added in Populife App on phone, the original passcode becomes invalid and you can get the new admin passcode in lock settings.
Page 19
8. Why can’t I delete my existing lock from the App? Make sure the lock is in the range of your phone’s Bluetooth (better less than 9m), and then simply delete it from your App. 9. Can I control the lock via voice? Populife deadbolt now supports voice control via Alexa.