Advertisement
Set Working Status
0.5L&1L flush mode change
The default flush mold of sensor is 0.5 L, you can switch to the
1L flush mode with flushing control stick. Operate as follow:
after initial power on, during the first 5 minutes, you can switch
the flush mode by putting the flushing control stick near the
right part of the sensor lens. When the flushing control stick is
near the right part of the sensor lens for 5 seconds. There will
be one quick rinse and the indicator light flashes twice after
you complete the 1L flush mode setting. If you need to reset
the 0.5 L flush mold, you can cut off the power completely and
restart the sensor, during the first 5 minutes, you can switch
the flush mode by putting the flushing control stick near the
right part of the sensor lens. When the flushing control stick is
near the right part of the sensor lens for 5 seconds. There will
be one quick rinse and the indicator light flashes once after
you complete the 0.5 L flush mode setting.
5
8
5
直流型
工作状态为二段式冲洗状态。
直流型
5
5
交流型
交流型
8
Advertisement
