Hardware Setup And Customization - THOMSON STUDIO CAMERA LDK 20(S) Technical Manual

Hardware Setup and Customization

The camera is delivered in a ready-to-use state,
however, there are occasions when it might be
necessary to re-adjust some functions after, for
example, fitting a new lens.
A large number of functions can be set-up using the
control facilities of the menu system. In addition to this
software set-up there are some functions which can be
selected or adjusted internally in the camera.
Refer to the next chapters for instructions.
Location of adjustments
Turn the two screws on the left side panel 90°
counterclockwise and swing down the cover. Turn the
two screws on the right side panel 90° counterclockwise
and swing down the cover.
2
1
Installation
6
3 5
4
Technical Manual LDK 20(S) - Studio Camera
Unless mentioned otherwise the adjustments for
hardware setup and customization are located at the
side of the following modules:
Front Module
1
Video Processor 1
2
Digital Video Processing
3
Subboard DSP
4
Sync. Shading
5
Data Processor
6
Power
7
Video Miscellaneous
8
Encoder
9
Video Mux Ext-TP Rec
10
Audio/Intercom TX-Rec
11
RTS Power Miscellaneous
12
7
12
8
9
10
11
2-3