Table of Contents
Advertisement
aus Troubleshooting
Fault
Detergent residue in
the appliance
Water marks on
plastic parts.
Wipeable or water-sol-
uble coatings are
present inside the ap-
pliance or on the
door.
Stubborn white coat-
ings are present on
tableware, inside the
appliance or the door.
Tea residue or lipstick
marks on tableware.
50
Cause and troubleshooting
The lid of the detergent dispenser is blocked by the
tab and will not open.
Position the tab in the detergent dispenser cross-
▶
wise, not vertically.
Tabs are used in the quick or short programme. Dis-
solving time of the tab is not attained.
Select a more intensive Programme or use Powder
▶
detergent.
Washing effect and dissolving performance are re-
duced after a prolonged storage time or detergent is
very lumpy.
Change your detergent → Page 28.
▶
Due to laws of physics droplet formation on plastic
surfaces is unavoidable. After drying water marks are
visible.
Select a more intensive programme.
▶
Position tableware at an angle.
▶
→ "Arrange tableware", Page 31
Use rinse aid.
▶
→ "Rinse aid", Page 27
Detergent substances are deposited there. These
coatings cannot generally be removed with chemicals.
Change your detergent → Page 28.
▶
Clean the appliance mechanically.
▶
Detergent substances are deposited there. These
coatings cannot generally be removed with chemicals.
Change your detergent → Page 28.
▶
Clean the appliance mechanically.
▶
Too little detergent is being used.
Increase the amount of detergent used or change
▶
Detergent → Page 28.
Washing programme selected too weak.
Select a more intensive washing programme.
▶
Adjust the sensitivity of the sensors.
▶
→ "Sensors", Page 11
Washing temperature is too low.
Select a programme with a higher washing temper-
▶
ature.
Too little detergent is being used or is unsuitable.
Advertisement
Table of Contents
