Table of Contents
Advertisement
aus Troubleshooting
Fault
Tableware is not dry.
Plastic tableware is
not dry.
Cutlery is not dry.
Appliance interior still
wet after wash cycle.
Food remnants are
left on tableware in
the top basket.
Remnants of food on
tableware.
48
Cause and troubleshooting
Use rinse aid to improve drying performance.
1.
Use a different combined detergent with a better
2.
drying performance.
Extra Dry not activated to improve drying perform-
ance.
Activate Extra Dry.
▶
Tableware removed too early or drying process not
yet ended.
Wait until the programme ends.
1.
Only remove tableware 30 minutes after the pro-
2.
gramme has ended.
Rinse aid used has a limited drying performance.
Use a name-brand rinse aid.
▶
Eco products may have limited effectiveness.
Not a fault. As plastic does not store heat so well, it
also does not dry as well.
No remedial action possible.
▶
Cutlery not arranged properly in the cutlery basket or
cutlery drawer.
Droplets can form on the cutlery contact points.
Arrange cutlery individually where possible.
1.
→ Page 31
Avoid points of contact.
2.
Not a fault. The condensation drying principle causes
water droplets in the tub – they are indeed desirable
here. The moisture in the air condenses on the inside
walls, runs off and is pumped out.
No action required.
Tableware in the top basket was placed too close to-
gether or top basket is overfilled.
Arrange tableware in the top basket with sufficient
▶
space in between. Position large items of tableware
at an angle, e.g. pans and ovenproof dishes.
Tableware is placed too close together or basket is
overfilled.
Arrange tableware with sufficient space in between.
1.
The spray jets must reach the surfaces of the table-
ware.
Avoid points of contact.
2.
Spray arm rotation of the lower spray arm is blocked.
Advertisement
Table of Contents
