Table of Contents
Advertisement
Fault
Detergent residue is
present in the deter-
gent dispenser or the
tablet collecting tray.
Excessive formation of
foam occurs.
Fault
Connection to home
network is not estab-
lished.
WLAN display is flash-
ing.
Home Connect cannot
be implemented cor-
rectly.
Fault
Refill indicator for
rinse aid lights up.
Refill indicator for
rinse aid does not
light up.
Fault
Water is left in the ap-
pliance at the end of
the programme.
Cause and troubleshooting
Detergent dispenser was damp when detergent was
added.
Only add detergent to a detergent dispenser when
▶
dry.
Hand washing-up liquid is present in dispenser for
rinse aid.
Immediately add rinse aid to the dispenser.
▶
→ "Adding rinse aid", Page 27
Rinse aid has been spilled.
Remove the rinse aid with a cloth.
▶
Detergent or appliance care product used causes ex-
cessive foaming.
Change the brand of detergent.
▶
Cause and troubleshooting
WLAN on router is not active.
Check the wireless network connection of your
▶
router.
Connection to home network is not available.
Activate the wireless network connection on your
▶
router.
Home Connect set incorrectly.
Please consult the documents supplied for
▶
Home Connect.
Technical fault is present.
Please consult the information about support in the
▶
documents supplied for Home Connect.
Cause and troubleshooting
Insufficient rinse aid.
Add Rinse aid → Page 27.
1.
Set the amount of rinse aid to be dispensed.
2.
→ "Setting the amount of rinse aid", Page 27
Rinse aid system is switched off.
Set the amount of rinse aid to be dispensed.
▶
Cause and troubleshooting
Filter system or area under the filters is blocked.
Clean the Filters → Page 42.
1.
Clean the Wastewater pump → Page 57.
2.
Troubleshooting aus
53
Advertisement
Table of Contents
