Troubleshooting - Scheppach DS200 Translation Of Original Instruction Manual

12. Troubleshooting

Fault
Power tool does not start
Power tool does not operate
with full power
Poor operation results
Considerable dust formation Brush edge worn out
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
Possible cause
Power supply interrupted
Power cord or plug defective
Other electric malfunction of the power tool Have an electrician check the tool
Extension cord too long and/or cross-
section too small
Power supply (e. g. generator) voltage too
low
Accessory worn out
Sanding plate worn out
Dust extraction not connected/switched on Connect/switch on dust extraction
Remedy
Check power supply by connecting another
power tool
Have an electrician check the tool
Use extension cord with permissible length
and/or adequate cross-section
Connect power tool to an appropriate
power supply
Have accessory replaced
Have sanding plate replaced
Have brush edge replaced
GB | 27