Download Print this page

HARVEY GYROAIR G700 Instructions

Dust processor

Table of Contents

Need help?

Do you have a question about the GYROAIR G700 and is the answer not in the manual?

Page 2 G700 Filter Assembly Replacing Instruction Filter Assembly Replacing Instruction Filter Assembly Replacing Instruction Filter assembly need to replace regularly (normally twice a year), it must use the Filter assembly need to replace regularly (normally twice a year), it must use the Filter assembly need to replace regularly (normally twice a year), it must use the matched filter assembly, as matched filter assembly, as Fig.1shown.
Page 3 As shown in Fig.4，remove 4 remove 4 locking screws (E)，then remove the filter cover then remove the filter cover。不清晰字母大小 Fig.4 3. Remove and Reinstall the Filter Assembly. Remove and Reinstall the Filter Assembly. As shown in Fig.5，remove 4 remove 4 screws(F)，these screws was fastened by nut(F) these screws was fastened by nut(F) inside the separator system, remove 8 screws(G), then remove the filter...
Page 4 As shown in Fig.7， remove hex nuts(K) remove hex nuts(K)，As shown in Fig.8, remove 6 As shown in Fig.8, remove 6 screws(L)， then remove the filter assembly and install a new one. then remove the filter assembly and install a new one. 字母大小...