Erasing; Erasing Tracks; Erasing A Whole Disc; Refreshing A Disc - Tascam Professional CD-RW900SX Owner's Manual

6 − After recording

Erasing

Erasing tracks

This operation erases the specified track and all sub-sequent
tracks from a recorded CD-RW disc.
NOTE
Once this operation has started, the STOP key cannot be used
to cancel it. Please check the track range to be deleted first.
Erasing track is operated only when unit is in continuos
playback.
1.
While stopped, press the ERASE/DEL key on the front panel
or the ERASE key on the remote control. Select the "ERASE
TRACK?" rotating the MULTI JOG dial or pressing the SKIP
key on the remote control.
To cancel the operation at this point, press the ERASE/DEL
or the ERASE key again.
2.
Push the MULTI JOG dial or press the ENTER key to enter the
function.
The display shows "Erase XX-XX" (the number of the first
track and last track to be erased).
Rotate the MULTI JOG dial or press the SKIP key to change
the track numbers you desire to erase.
To cancel the operation at this point, press the ERASE/DEL
or the ERASE key again.
3.
Push the MULTI JOG dial or press the ENTER key to operate
the function.
The display shows "Sure?".
To cancel the operation at this point, press the STOP key.
4.
Push the MULTI JOG dial or press the ENTER key again to
proceed the operation.
The display shows Erase flashing and the remaining time.
The unit starts counting down from a time shown on the
display.
5.
When the tracks have been erased, "Complete" will appears
on the display.
28
TASCAM CD-RW900SX

Erasing a whole disc

When you want to erase a whole disc (all the tracks on a disc),
follow the procedure below:
NOTE
Once the operation is proceeded, the STOP key cannot
function. Please confirm before the operation.
1.
While stopped, press the ERASE/DEL key on the front panel
or the ERASE key on the remote control.
Select the "ERASE DISC?" by rotating the MULTI JOG dial or
pressing the SKIP key on the remote control.
To cancel the operation at this point, press the ERASE/DEL
or the ERASE key again.
2.
Push the MULTI JOG dial or press the ENTER key to enter the
function. The display shows "Sure?".
To cancel the operation at this point, press the STOP key.
3.
Push the MULTI JOG dial or press the ENTER key again to
proceed the operation.
The display shows Erase flashing and the remaining time.
The unit starts counting down from a time shown on the
display.
4.
When the disc has been erased, "Complete" appears then
"Blank Disc" will appear on the display.

Refreshing a disc

Refreshing the disc makes a disc usable again. This operation
destroys all data on the disc.
1.
Load the disc, and the unit in stop mode, press the ERASE/
DEL key on the front panel or the ERASE key on the remote
control. Select the "REFRESH?" rotating the MULTI JOG dial
or pressing the SKIP key on the remote control.
To cancel the operation at this point, press the ERASE/DEL
or the ERASE key again.
2.
Push the MULTI JOG dial or press the ENTER key on the
remote control to enter the function. The display shows
"Sure?".
To cancel the operation at this point, press the STOP key.
3.
Push the MULTI JOG dial or press the ENTER key again to
proceed the operation.
The display shows Erase flashing and the remaining time.
The unit starts counting down from a time shown on the
display.
4.
When the disc has been refreshed, "Complete" appears then
"Blank Disc" will appear on the display.