Ptz; Baud Rate - Swann DVR8-2500 Operating Instructions Manual

System
Setting the Time
1. Open the DATE / TIME menu, located in the SYSTEM menu.
2. By using the mouse or the arrow buttons, navigate to the numeric time
display and left click or press select.
3. The first digit (see example to the right) will now be highlighted for
editing.
4. Using the pop-up keypad, use the mouse of the arrow buttons to select
the digit that you want. Left click or press select to choose a digit.
5. Confirm your selection by highlighting and pressing select or left clicking
with the mouse the ENTER button
The time and date settings are not lost when the DVR is turned off or unplugged from power. There is a small battery
within the DVR which powers the clock (and the BIOS) of the DVR whilst power is not connected. This battery usually
lasts quite a long time (months to a charge). If the DVR is unplugged for an extended period, the battery's charge might
run out and your settings may be lost.

PTZ

PTZ stands for "Pan, Tilt, Zoom" and is the basic control method for attaching movable cameras to your DVR. There are
a few variables and options that you can set from this menu. We've compiled a short list of what these values are and
what they mean - however, the only important thing to do is to configure the PTZ settings in the DVR as required by
your camera or camera mounting system!
You'll need a list of the technical specifications for your camera (usually located in the main instruction manual). Once
you've got this, let's dive into configuring the PTZ settings. You'll find them in the PTZ submenu, located in the DEVICES
menu.
Protocol
It is important to use the correct protocol for the PTZ system being used (this will
be explicitly stated somewhere in the PTZ cameras documentation). The DVR8-2500
supports Pelco-D and Pelco-P - make sure any PTZ cameras you connect to the DVR
use one of these two protocols - and select the most appropriate protocol for your
system here.

Baud Rate

A baud rate is a measure of speed of information transfer in symbols per second.
So, for example, a COM port on a computer which communicates at 9.6kbps
would have a baud rate of 9600 (each symbol in this case is a single bit of data).
If this sounds a little complex then, yes, actually, it is! The good news, is you just
need to find out your PTZ camera's preffered Baud Rate (it will be stated in the
documentation) and set the DVR's Baud Rate to match).
23