Panasonic EH-XT20 Operating Instructions Manual page 19

4
4
Press the switch and select a temperature
level of the titanium head.
• Press once to switch to the next temperature level.
(Except for COOLING mode)
LOW MED
• Lamp display will automatically switch to mode
function display after approximately 5 seconds after
selection.
(Temperature level will not be displayed.)
• Warming may fail when the ambient temperature is
below 15 °C.
Memory function
The appliance records last used microcurrent and
temperature level, and starts with the same setting
when switched on.
This memory function will reset when the appliance has
not been used for a long period of time or when the
battery has ran out.
PB017050 - EH-XT20 _(01EN)_11-27-18.indd 19
HIGH OFF
5
5
Hold the main body firmly
touching the microcurrent panel
(a) on the rear of the main body.
• When the titanium head is applied
to the skin in this state, the
titanium head detects the skin and
vibrates.
(See page 17.)
• If the titanium head is applied to
the skin immediately after
selecting the microcurrent or
temperature level, the lamp
display will switch to mode
function display even before 5
seconds have passed.
6
6
Move the titanium head while touching the skin.
PURIFYING mode
MOISTURIZING
mode
AUTO mode
• The power will be automatically turned off after
each mode is completed.
• You can also turn it off by a long press of the
POWER/SELECT switch.
a
(See page 21.)
(See page 21.)
(See pages 21 and 22.)
19
2018/11/27 16:55:26