Installation (External Ventilation) - Klarstein BARELLA Manual

EN
22

INSTALLATION (EXTERNAL VENTILATION)

Assembly of the V-flap
If the cooker hood does not have a pre-assembled V-flap, install the parts as follows:
1. Install the first half (2) in the housing (6).
2. The pin (3) should be facing upwards.
3. Insert the axle (4) into the holes (5) on the housing.
4. Repeat all steps for the second half of the flap.
Installation
If you have an outside air outlet, the hood can be connected
via a suction duct (enamel, aluminum, flexible tube or non-
flammable material with an inside diameter of 150 mm) as
shown on the right.
1 Remove the plug from the socket before installation.
The cooker hood should be placed at a distance of 65-75 cm above the
2
cooking surface for the best possible effect.