Operation; Air Ventilation Setting - Klarstein ACV-61B Manual

Way two:
• Drill 6 holes of 4mm diameter at the bottom of the hanging cupboard
• Put the one way valve on the cooker hood, then install the cooker hood on the bottom of the
cupboard, tighten the hood with enclosed 6 screws.
• Install the adjusted board on the bottom of the hood in order to keep out the gap between hood
back and cupboard.
• Connect the plug into the power.
• Push the switch ② into "1, 2, 3", the motor will be on "low, mid, high" three speeds, push into "0",
• Push the switch ① into "I", the lamp be on; push into "0", the lamp be off.
the motor will be off.
• Outdoor exhausting: Turn the adjuster to outdoor position(pic.7A), install the outlet, turn on the
cooker hood, then the air will be vented from the outside outlet. See pic 7C
• Recycling: the recycling mode with carbon fi lter ,Turn the adjuster to indoor position (pic.7B),
install the outlet cover, turn on the cooker hood, then the air can be vented from the inside outlet.
See Pic 7D
Note: The charcoal fi lter is mounted on the back of the grill and must be changed once three month.
Warning: the charcoal cannot be washed or recycled. It should be changed at most after 120 hours using.
The carbon fi lter shouldn't be exposed to heat.
Warning: the charcoal cannot be washed or recycled. It should be changed at most after 120 hours
using. The carbon fi lter shouldn't be exposed to heat. using. The carbon fi lter shouldn't be exposed to heat.

Operation

Air ventilation setting

14