HermanMiller Canvas Office Landscape Installation And Disassembly For Recycling Instructions page 4

Universal work surface leg

Hide thumbs Also See for Canvas Office Landscape:

Panel Support:

8. Insert Teeth on Panel Support (C) into slots in frame at desired height.

9. Rotate Panel Support outward. Insert Support Clip(D) into place.

10. Secure Clip in place with 2 short Pan Head Screws(F).

11. Place Work Surface into position aligning 2 inside holes in support with pilot

holes in Work Surface. Mark all screw hole location. Remove Work Surface.

Drill Pilot holes. Be Careful not to drill through Work Surface.

12. Return Work Surface to Panel Support.

13. Install 5 long Pan Head Screws(E) per Support.

® Y, Z and Canvas Office Landscape are among the registered trademarks of Herman Miller, Inc.

Illustrations and specifications are based on the latest product information available at the time of publication.

The right is reserved to make changes in design and specifications at any time, without notice, and also to discontinue products.

Pilot Holes

Part no. 1b6y4f rev C.