Installation
Installation of biopsy controller holders
The biopsy controller is attached to the rear cover of the stand. To install the holders
proceed as follows:
1.
2.
Fig. 2 Rear cover, from the back side
Siemens AG
Medical Solutions
Install the three holders (2/Fig. 2) by using the nuts (3/Fig. 2).
Install the two standoffs (4/Fig. 2) by using the screws (5/Fig. 2) and the washers
(6/Fig. 2).
2
3
UP
A
B
6
4
SPB7-230.814.01
Page 3 of 24
Rev. 01
10.04
CS PS 24
985 – 5 mm
1
5
5 - 3
5
Opdima
Installation