AEG ARE i2 - HF Installation Manual page 10


Put all the removed parts (nut (5), cable fastener (3), pipe (4),) and the cable pipe of the SAB Cab
as well (1 to 4) to the cable.
Figure 3: Mounting for the cable

Remove the outer isolation of the cable at a length of 6cm .

Remove the isolation of the wires at a length of 6mm and stick a covering hull to the litz wire.

Put the cable to the cable pipe. The length of the cable coming out the SAB Cab must long enough to
do all further installation steps in an easy way.

Stick the pipe (4) into the cable fastener (3).

Stick the cable fastener (3) into the cable pipe.

Connect the cables into the right places of the MINI-COMBICON-Connectors (6).

The pin assignment is shown in the figure below.

Put the MINI-COMBICON-Connectors into the SAB cab. Look after the color coding.
--------------------------------------------------------------------------------10/50--------------------------------------------------------------------------------
6
7
5
4
Cable
3
1