Youcan Robot BW Space Pro User Manual page 24

Mode: Set the control mode of the drone, and the default is mode 1; press the
button once, set the Mode 2, and so on.
Lock: By default, click the button to lock the drone.
Home: Press power button for 3-5 seconds, and the remote controller turns on.
Low-angle shoot: Set the pitch angle of 0 °~45 °, and the larger the number, the
larger the angle. Each time you press the button, the pitch angle increases by 5 °.
High-angle shoot: Set the pitch angle of 0 °~-45 °, the smaller the number, the
larger the angle. Each time you press the button, the pitch angle increases by 5 °.
Speed down: Press the button once to shift into lower gear.
X
Speed up: Press the button once to shift into higher gear.
B
Charging indicator: Displays the light status when the remote is charging.
Left joystick: Control the movement of the machine, consistent with the mode
in the APP.
Right joystick: Control the movement of the machine, consistent with the mode
in the APP.
Image stabilization: Click the button to turn on image stabilization ; Click again
Y
to turn off image stabilization.
Pair button for phone: used to pair with the smart phone.
A
Brightness reduction: manually reduce the brightness of the light, and tap the
L2
button once to reduce the brightness.
Zoom in: enlarge the image.
Brightness enhancement: manually increase the brightness of the light, and click
R2
the button once to increase the brightness.
Zoom out: reduce the image.
Photo: Tap the photo buttons to take photos.
L1
Record: click the button to start recording; click it again to stop recording.
R1
• Using the Remote controller
1
Charging for the Remote Controller
Connect the USB charging cable to the charging
port of the remote control, the charging indicator
lights up red and flashes slowly, to start charging;
the charging indicator lights all light up red and
stop flashing, indicating that the remote is fully
charged.
22
Charging
interface