treesse GEN-X Installation Manual page 9

_INSTALLATION
Page 9
Position the tub in the installation corner and
place it perfectly level using the feet 1,3,4 and
6.
ATTENTION
To adjust the tub, act only on the feet and not
on the threaded rods.
All four feet mentioned above MUST rest on
the ground perfectly with the tub in installation
position.
Incorrect support can compromise the
tightness of the door.
Once positioning is obtained, lock the feet
using the nut on each of them.
Now you can adjust feet 2 and 5 until they
touch the floor, without forcing. Lock the feet
with the nut found on each of them.
ATTENTION
Feet 2 and 5 should not raise any of the
previously adjusted feet. Failure to do so would
compromise the stability and the structure of
the tub, especially the door seal.
Connect the tub drain to the ground fittings as
indicated in the technical data
Connect the tap to the wall fittings as indicated
in the technical data sheet.
sheet.