Zte MC7010 Quick Start Manual page 4

4. Firstly, fasten the backplane to the installed bracket through the upper and lower slots, and align
the hole on the backplane with the hole on the bracket. Secondly, use one M3 crosshead screw
to install the MC7010 on the bracket.
4. Use four M3 crosshead screws to install the backplane on the device.
13
15
Installing the Device against a Pole
1. Use a screwdriver to loosen the clamp and release the buckle.
2. Pass the clamp through the U-shape groove on the bracket to install the bracket against the
pole.
CAUTION:
The screw hole of the bracket faces upwards. Do not install the bracket upside down. Otherwise,
the screw cannot be installed later.
3. Adjust the clamp to the proper tightening position, press the buckle and use a screwdriver to
lock the clamp to fix the bracket.
5. Firstly, fasten the backplane to the installed bracket through the upper and lower slots, and align
the hole on the backplane with the hole on the bracket. Secondly, use one M3 crosshead screw
to install the MC7010 on the bracket.
NOTE:
Before installing the device on the bracket, you can move the device horizontally and slowly on
the pole to further adjust the position if needed.
14
16