Husqvarna FS 600 E Operator's Manual page 19

• Push the ON/OFF button to "I" to start the product.
In less than 5 seconds the product operates at the
correct operation speed.
To stop the operation
Note:
The lever for the cutting depth wheel must
always be locked when the cutting depth wheel is not
in use.
1. Pull the lever to unlock the cutting depth wheel.
2. Turn the cutting depth wheel clockwise until the
cutting blade is slightly above the ground.
3. Push the lever to lock the cutting depth wheel.
4. Turn the water tap or push the water valve to stop
the water supply. Refer to
water supply on page 18 .
To stop the product
WARNING:
for a while after the motor stops.
Note:
The lever for the cutting depth wheel must
always be locked when the cutting depth wheel is not
in use.
1620 - 003 - 28.02.2022
To connect the external
The cutting blade rotates
1. Turn the cutting depth wheel clockwise to lift the
cutting blade. Push the lever to lock the cutting depth
wheel.
2. Push the ON/OFF button to "0" to stop the motor.
3. Engage the parking brakes.
4. Disconnect the power plug.
To cut the surface
Note:
The lever for the cutting depth wheel must
always be locked when the cutting depth wheel is not
in use.
1. Align the cutting blade with the marks on the ground
or the guide cut.
19