Function Of The Readyrs - Fichtelbahn ReadyRS Manual

FichtelBahn
The next figure shows the ReadyRS node as last module of the BiDiBus. In this case
both termination jumpers for BiDiBus and DCC termination have to be fitted on the
ReadyRS node.
Please notice:
If the first and last module of
the bus are not terminated
with the termination jumpers
the distortion of the signal
might lead to errors in the data
transmission. If the termination
jumper is fitted on a module
within the bus the transmission
might be disrupted. Both cases
will not lead to any damage of
the modules.

05. Function of the ReadyRS

With the LZV100 command station, the company Lenz Elektronik GmbH introduced a
feedback bus, where the connections are identified as R and S.
All kinds of detectors can be connected to this RS bus e.g. track occupancy detectors.
The BiDiB node ReadyRS converts the feedback information of the RS bus feedback
detectors into BiDiB messages.
The ReadyRS module has been tested with the following detector modules:
Lenz Elektronik GmbH
Blücher Elektronik
Littfinski Daten Technik (LDT)
Manual ReadyRS V1.0
Manual Version 1.0
Hersteller
... bis zu 32 Teilnehmer
Abschluss-Jumper
setzen
X
LR101, LS100
GBM16XL V 1.4, GBM16XN V 1.1
RS-16 Opto, RS-8
Page 21
R
eady
Line
* ... Abschluss-Jumper intern gesetzt
X
TERM Power
TAST
ID DCC BiDiB
12V - 18V
+ - 12V DC IN
DC
R
eady
ReadyBoost
Line
FichtelBahn
BiDiBus DCC-Booster 4A
Made in Germany
Booster OFF DCC OUT
EXT.
Booster ON
max. 4A
STOP
DCC2 DCC1
STATE
DCC
EXT.STOP
Produkt
© 2022 FichtelBahn®
Technical changes and errors reserved
X
GBM16TS
16fach RailCom -Belegtmelder
DCC IN
DCC 2
DCC 1