Download Print this page

TOPRO Troja Original Instructions For Use Manual page 8

Hide thumbs Also See for Troja Original:

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
EN
EN
NO
DE
3
Unfolding / Folding
NL
Unfolding: Release the lock clamp
positioned at the seat bars (A). Press the
SV
seat bars down and out. The side frames
will slide apart. Press down the seat bars
DA
(B). You will hear a clicking sound. The
rollator is now locked in its open position.
Folding: Pull the strap on the seat (C)
FR
and press the side frames together.
Lock the clamp (D) over the seat bars.
Carrying the rollator: The rollator
must not be carried by the seat
strap or the brake cables.
Fold the rollator together as shown on
the illustration (E). Carry the rollator
by the seat bars (F) when folded.
4
Handles / Memory function
Height adjusting: Unscrew the lock
wheel (A) (approx. 2 turns). Adjust the
handle tubes to a suitable height then
pull them slightly up and down (C)
until you hear a clicking sound. Tighten
the lock wheel (A) again. Adjust both
handles to the same height by compa-
ring the number scale on each side. It is
recommended that the handles are set to
the same height as your wrists when your
arms are hanging alongside your body.
Memory Function: Decide on the height
of the handles (see number scale). Count
visible holes at the back of the handle
tubes. Unscrew the lock wheel (A). Pull the
tube (B) out of the frame. The fastening
piece (D) will now follow the handle tube.
Move the fastening piece (D) so that the
number of holes above it equals to the
previously counted holes. Fit the red
memory chip (E) on the handle tube in
the first available hole under the fastening
piece (D). Push the handle tube (B) and
fastening piece (D) down and into the
side frame (F). Screw the lock wheel (A)
halfway in. Pull the handle (G) up until it
stops, and then tighten the lock wheel (A)
properly. From now on, when the handle
is in the lowest position, it will stop in
the pre-set position when pulled up.
Art. No. User Manual: 105035 – Revision A, 2021-11
5
Brakes
Make sure the brakes are working
before each trip. Each brake lever (A)
works on each of the rear wheels. Do
not drive or push the rollator while
the parking brakes are in use!
Parking brakes: Push both brake levers
(A) down until they lock. Both rear wheels
are now locked. Squeeze both brake levers
upwards to release the parking brakes.
Driving brakes: Pull both brake levers
(B) upwards to reduce speed. Do not use
continuously while the rollator is in motion.
Adjusting / checking: Loosen the nut
(C). Tighten the brake cable (D) with
the adjustment screw (E). Adjust both
brake blocks so the distance to the wheel
surface is approximately 1 mm (F) and
then tighten the nut (C). Make sure the
brakes are not adjusted too tight and
pressing hard into the rubber of the
wheels when the parking brake is on.
Maintaining: Clean the brake block
(F) and the brake spring (G) frequently.
The wheels and brakes can be replaced
if they are worn out or damaged.
6
Seat
The rollator has a safe and convenient
net seat, through which you have a
view to the ground while walking. It can
easily be wiped with a cloth if needed.
The parking brakes must be on before
using the seat. Push both brake levers
downwards until they lock (A). Both
rear wheels are now locked. Sit with
your back towards the basket (B).
7
Edge guard / Tilt function
Edge guard: The edge guards (A),
which are in front of the rear wheels
prevent the rear wheels from cat-
ching on corners, door frames etc.
Tilt function: To use the tilt function
use the front of the foot and press down
on the tilt pedal (B), which is beside the
rear wheel. This helps to tilt the rollator
over thresholds, edges etc. Please note:
Take care when descending kerbs.
4
TOPRO Troja Original
Basket
The basket holds up to 10 kilos (model M
& S) / 5 kilos (model X). It can be removed
and washed gently at up to 60 °C.
Transport
The rollator should be transported in
the folded and locked position (see
paragraph 3 Unfolding / Folding). Ensure
that the lock clamp is on, so that the
rollator cannot unfold unintentionally. Be
careful when loading the rollator into a
vehicle, giving attention to securing it.
Storage
The rollator should be stored in an upright
position. If stored outdoors it must be un-
der a cover to protect it. Do not leave your
rollator unattended. Do not put heavy
items on top of the rollator during storage.
Cleaning
The rollator can be hosed and washed
with normal household detergents. Do
not use abrasives. Avoid flushing directly
against bearings (wheels, front forks).
Disinfection
Disinfection must only be carried out by
authorized personnel and by wearing
sufficient protective equipment. The
surface of the rollator must be cleaned
with a disinfectant containing 70–80 %
ethanol. We advise against disinfectant
that contains chlorine and phenol.
The manufacturer cannot be held respon-
sible for any damage or injuries that might
occur using harmful disinfectant or disinfec-
tion carried out by unauthorized personnel.

Advertisement

loading