Graco Magnum TrueAirless ProX19 Owner's Manual page 31

3. If needed, unscrew Inlet Screen from
Suction Tube. Turn Prime/Spray Valve
down to PRIME position.
4. Place drain tube in waste pail. Turn
pressure control to the START position.
5. Install battery, see Battery Installation
and Removal, page 14.
6. While holding the Suction Tube above
the sprayer, pour approximately 2
ounces (1/4 cup) of Pump Armor into
Suction Tube and turn Power Switch
ON. Button is illuminated when ON.
3A9019A EN
7. When Pump Armor is flushed through
the sprayer and out the Drain Tube, turn
Power Switch OFF. Replace and tighten
child-proof cap for storage.
8. Screw Inlet Screen back to Suction
Tube. Ensure that spray gun and hose
stay attached to sprayer.
9. Turn Spray/Prime Valve horizontal to
SPRAY position for storage.
10. Turn ON/OFF switch to OFF position.
Button is not illuminated when OFF.
Remove battery, see Battery
Installation and Removal, page 14.
11. Secure a plastic bag around Suction
Tube and Drain Tube to catch any drips.
Storage
31