Advertisement
I N S TA L L AT I O N – D U C T E D
When the cooker hood and appliance supplied with energy other than electricity are
AT T E N T I O N :
simultaneously in operation, the negative pressure in the room must not exceed 4 Pa (4×10-5 Bar).
When the cooker hood and appliance supplied with energy other than electricity are
simultaneously in operation, the negative pressure in the room must not exceed 4 Pa (4×10-5
Drill 3 holes using an 8mm drill bit to accommodate the bracket. Screw and tighten the bracket
Bar).
onto the wall with the screws (ST4x30mm) and wall plugs provided (A).
Drill 3 holes using an 8mm drill bit to accommodate the bracket. Screw and tighten the bracket
onto the wall with the screws (ST4x30mm) and wall plugs provided (A).
Level up the cooker hood and hang onto the wall bracket hook.
Level up the cooker hood and hang onto the wall bracket hook.
After hanging the hood on the bracket, open the front panel and remove the grease filters, mark 2
holes inside the hood for safety screws. After marking, remove the hood, drill two holes and insert
2 wall plugs. Hang the hood back onto the wall and finally fix the safety screws with 2 screws
(ST4x30mm) (B).
(B).
Please keep this instruction manual for future reference
Wall Bracket
A
B
Instruction manual SP612 / SP912
11
Advertisement
