TP-Link TL-WPA4220 User Manual page 11

Chapter 2
For example,
wireless network is still not big enough to reach the top floor. So I bought a new powerline
extender to extend the wireless network.
How can I do that?
1 Plug the new powerline extender into a wall socket near one of the existing powerline
extender.
2 Check the new extender's Powerline LED
• If it is on, follow Step
• If it is off, follow Step
3 Add the new powerline extender to the existing powerline network by pairing two
powerline devices.
a . Press the Pair button on the existing powerline device for 1 second. The Power
b . Within two minutes, press the Pair button on the new powerline extender for 1
4 Relocate the new extender to the Wi-Fi "dead" zone.
Note: A blinking Powerline LED indicates poor signal strength. Move the extender to another location.
Downloaded from ManualsNet.com
I already set up a wireless network using powerline devices, but the
Existing Powerline Device
(For demonstration only)
4 > A.
3 and Step
LED starts blinking.
Note: If the Power LED does not blink, press the button again.
second. The Power LED starts blinking. When the Powerline LED turns solid on,
the pairing process is complete.
Blinking
Existing
Powerline Device
search engine
e
r l i n
w e
P o
New Powerline Extender
TL-WPA4220
. Is it on?
4 > B.
Blinking
within 2 minutes
New Powerline Extender
TL-WPA4220
Initial Use
On
9