Table of Contents
Advertisement
Deflection amplitude setting for 50PH36P (HIT/WID adjusting method under muted convergence)
A
3rd flag 1st flag
Horizontal amplitude: Left and right register marks of Philips pattern C + D = 7 (See A of the upper figure.)
Vertical amplitude:
The point where the center between 1st and 2nd vertical line outer from the upper and lower register
marks of Philips pattern is overlapped with flags contacts the screen edge. If the amplitude is uneven
horizontally and vertically, make HIT adjustment so that B shown in the upper left of the upper figure
comes to contact the screen edge.
Next, pay attention to the C point. Check and confirm that the castration border line contacts through
2nd line to 4th line outer from the lower register mark.
Vertical amplitude adjusting method for PAL/100Hz mode
1 Make adjustment on the basis of the upper screen.
2 Do not make VLIN adjustment for SUPERLIVE.
3 Screen adjusting range: ±1
(DFS-100Hz)
B
0 point
0
C
∗ Green pattern under the muted convergence
Screen edge
Castration border line
– 20 –
A
WIDE
SUPERLIVE
SUBTITLE
CINEMA
Advertisement
Table of Contents
