Toshiba 43PH36P Service Manual page 10

LOCATION OF SCREEN AND FOCUS VR'S
To remove the Speaker grille and Front panel.
REPLACEMENT OF HIGH VOLTAGE CABLE
ANODE LEAD
RUBBER BOOT
LEAD HOLDER
Fig. a
Front grille
Z450 TPA5011AH
– 8 –
B G
1. When replacing Anode Lead or Anode Cap with new
one, remove Lead Holder from old lead as shown in fig-
ure below, and put it on new lead. Do not throw away
Lead Holder.
NOTE : THE LEAD HOLDER IS ATTACHED TO
TPA5011AH (Z450), BUT IS NOT ATTACHED
TO ANODE LEAD AND ANODE CAP. RUBBER
BOOT IS ATTACHED TO ANODE LEAD AND
ANODE CAP.
2. Detaching Lead Holder
RUBBER BOOT
LOCK LEAD HOLDER
Fig. b
R
FOCUS VR's
SCREEN VR's
OLD
ANODE LEAD
or
ANODE CAP
Cut here rubber boot
and lead together to
detach Lead Holder.