Table of Contents
Advertisement
Installation
Installation
Notes
• The installation should be done by qualified service personnel or system installers.
• If the ceiling material is not strong enough to hold the installation screws, the camera may
fall off. Reinforce the ceiling as needed.
• Take care not to drop the product during installation. Do not allow anyone to stand below the
installation area.
1) Remove the dome cover and shield case from the main body by loosening the three
dome cover screws.
2) And then remove the main body from the mounting bracket by the four main body screws.
Adjust the panning, tilting and rotate mechanism while checking the position on the monitor
145°
170°
Pan Base
-170°
COLOR DOME CAMERA
Mounting Bracket
Main Body(Camera)
Dome Cover
73°
195°
Rotate Base
Tilt Base
10
User Guide
1) You can adjust camera to any direction by using Pan, Tilt, Rotate mechanism.
• Pan Base moves by 170° to each direction and 340° on the whole.
• Tilt Base covers total 146° angle(73° to each side).
• T he angle range of the Rotate Base is the same as that of the Pan Base.But one
direction range is 195° and another is 145°
2) Methods of adjustment
• Wall installation
...After mounting the camera to the wall, loosen the rotate base holding screws.
...Adjust to the correct panning angle.
...Then adjust the tilt angle by rotating the base.
...Once complete re-tighten the rotate base holding screws.
• Ceiling installation
...After mounting the camera to the ceiling, loosen the rotate base holding screws.
...Adjust to the correct panning angle.
...Then adjust the tilt angle by rotating the base.
...Once complete re-tighten the rotate base holding screws.
Notes
• When adjusting the rotating angle, loosen rotate base holding screw as follows Figure A. And
then tighten it again.
• When adjusting the tilting angle, grip the tilt base and adjust tilting angle.
• When adjusting the panning angle, loosen pan base holding screws as the follows Figure B.
And then tighten them again.
• The 2 LED sections can be tilted inside the case to a maximum angle of 73°, this however
will not alter the illuminated range.
Rotate Base Holding Screw
Pan Base Holding Screw
• When adjusting the tilt mechanism hold the Tilt base and NOT the lens.
COLOR DOME CAMERA
Rotate Base Holding Screw
11
User Guide
Advertisement
Table of Contents
