iRobot Roomba RVE-Y1 Owner's Manual page 8

Charging
EN
CLEAN
• Place the robot on the charging station to activate
the battery.
Note:
Your robot comes with a partial charge, but we recommend that
you charge the robot for 3 hours prior to starting the first cleaning job.
• The robot uses a small amount of power whenever it is on the
charging station. You can put the robot in a further-reduced
power state when not in use. To put your robot into Reduced
Power Standby Mode, remove the dust bin and tap the clean
button 5 times. To exit Reduced Power Standby Mode, place
your robot on the charging station and tap the clean button.
For more details on this Reduced Power Standby Mode, refer
to the FAQ page on our website.
• For long-term storage, turn off the robot by removing it from
the charging station and holding down the clean button for
3 seconds with one wheel off the ground. Store the robot in a
cool, dry place.
4 For more information, visit global.irobot.com
Light Ring Spiral while charging
White Spiral: charging
Red Spiral: charging, low battery
A solid white light will indicate the battery
charge percentage of your robot
When your robot is fully charged, the
light ring indicator will intermittingly
pulse white at the rear.
Cleaning
• Your robot will automatically explore and clean your home in neat rows,
avoiding obstacles using its front-facing camera. It will return to the
charging station at the end of a cleaning job and whenever it needs to
recharge.
Your robot is able to recognise and avoid objects. However, it is
still recommended to remove excess clutter before cleaning.
• To end a job and send the robot back to its charging station, hold the clean
button down for 2-5 seconds. A blue light ring pattern will indicate that the
robot is seeking the charging station.
• When your robot detects an especially dirty area, it will engage Dirt Detect™
mode, moving in a forwards/backwards motion to clean the area more
thoroughly. The light ring indicator will flash blue.
When the robot senses its bin needs to be
emptied, the light ring indicator will illuminate in
a red sweeping motion towards the rear.
Just press the clean button
Tap to Start / Pause / Resume
Hold for 2-5 seconds to end a job