HP Z34c G3 Maintenance And Service Manual page 24

IMPORTANT:
• Repair Condition: Connector repair is only for out of warranty.
• Repairing must operate by professional repairers (Note) in repair center, not
applicable for end user.
• Electrostatic protection is required when component replacement is required.
• The monitor meets ROHS, please use Lead-free solder wire for soldering.
• If Connector need to replace, must check specification and part number whether
match the BOM and location.
• If connector need to replace, please insert new parts carefully because the near
pin may cause short circuit by inappropriate operate.
• DO NOT allow any liquid on the board. Water and moisture may cause short-
circuit to the electronic components and lead to malfunctions.
• The fusion point of Lead-Free solder is requested. Repairing with conventional
lead wire may cause damage.
• Work quickly to avoid overheating the circuit board as soon as you confirm the
steady soldering condition.
• Keep the soldering iron tip clean and well tinned and when replacing parts.
• A close inspection of the circuit board revealed look in good condition.
• After repaired, must connect source to each port to check Main board function is
ordinary.
Note: (The requirement of professional repairers' regulation by ERP lot5)
(1) The professional repairer has the technical competence to repair electronic
displays and complies with the applicable regulations for repairers of electrical
equipment in the Member States where it operates. Reference to an official
registration system as professional repairer, where such system exists in the
Member States concerned, shall be accepted as proof of compliance with this
point.
(2) The professional repairer is covered by insurance covering liabilities resulting from
its activity, regardless of whether this is required by the Member State.
22