Advertisement
2019/01/30 02:46:26 (GMT+09:00)
④Regardless of Good board or Defective board, always put it
on ESD cushion/sheet slowly.
⑤Do not stack up
⑥Keep vertical position and put in/take out from Box.
Always put in to ESD bag then place into Box/Container Box.
⑦Do not hold Heat-Sink when take out or install it..
2) Caution for Board handling(ESD)
Be sure to observe the following contents.
①When take off Rear-Cover,
do not touch to board
②Use ESD wrist-strap
9
SYS SET
Advertisement
