Typical Operation Cycle Table - Dometic ESKIMO ICE Operation Manual

typical operation cycle table

ACTION
Initial Start Up Via Breaker
Pump ON
Auger ON
Compressor ON
Ice Production
BIN FULL
Auger Clears
Machine Shuts Down
Ice removed from bin
Pump ON
Auger ON
Compressor ON
Ice Production
FAULT Trip - HPF, LPF,
etc.
Clearing Auger
Machine Shuts Down
Fault Trip Corrected
Pump ON
Auger ON
Compressor ON
Ice Production
Note:
Above is an example of a typical operation cycle based on default values, cycle will change depending on end
user parameter changes.
Figure 2. Typical Operation Cycle
eNGLish
Delay before Next Step (in seconds) and/or description of action
60 Assumed display is in ON position. If not, turn unit on via display.
30
15
Will continue until sensor reads bin full for 30 sec., fault trip or unit manually
shut down.
30
Sensor reads bin not full, calls for ice production.
30
15
Will continue until sensor reads bin full for 30 sec., fault trip or unit manually
shut down.
30
60
30
15
Will continue until sensor reads bin full for 30 sec., fault trip or unit manually
shut down.
eskimo ice systems
7