Siemens Siremobil Compact L Instructions Manual page 10

10 Replacement of the 15" LCD Color TFT Display
Replacing the TFT display
•
Disconnect the low voltage plug from the TFT display
•
Disconnect the VGA plug from the TFT display.
•
Loosen the 4 screws at the rear side of the TFT display and remove it from the holder
NOTE
Fig. 3
•
Install the new display with the 4 mounting screws.
•
Connect the low voltage plug and the VGA plug at the new display.
•
Check the input selection switch (at the bottom side of the TFT display).
The switch can be set in 3 positions:
Position to the rear: VGA input selected
- Set this position, if VGA video cables are used.
Middle position: BNC-Input selected, 75 Ohm terminating resistor is off.
- Set this position only, if additional video components are installed at the same video
source as the TFT display.
Position to the front: BNC input selected, 75 Ohm terminating resistor is on.
- Set this position, if BNC video cable is used and no additional video component is
installed at the same video source as the TFT display is connected.
•
Check the functions of the TFT displays.
•
Check the automatically detected video mode.
•
Check the geometry of the displayed image.
•
Adjust the brightness, contrast and back light intensity.
Siremobil Compact L
Hold the TFT display while loosening the mounting screw to
prevent damage to the TFT display or the environment
SPR2-130.841.03
Rev. 02
Page 10 of 20
06.05 CS PS 24
1
Siemens AG
Medical Solutions