3x Mounting Screws doorbell system. Ring your existing doorbell 3x Wall Anchors and listen for the chime. If it rings, we know your existing doorbell system is working.
Page 3
Jumper Cable. This is essential to The Jumper Cable bypasses keeping you and your and disables your existing new Ring Doorbell safe. doorbell chime, and must be installed before you install If you’re not sure which your Ring Doorbell. breaker controls your...
Page 4
Remove the cover from your Connect the Jumper Cable. doorbell chime. Connect one end of the After you’ve located your Jumper Cable to the “Front” doorbell chime and turned off terminal, and the other to the power at the breaker, remove “Trans”...
Page 5
Uninstall your existing Mark the screw holes. doorbell button. Using your Ring Doorbell as Remove your doorbell from a template, mark the location the wall. of the two mounting holes on your wall. Disconnect the wires. Make sure they don’t fall back inside your wall so you can access them later.
Page 6
(If you’re installing on wood or If your doorbell wires are too siding, you can skip this step.) short to reach your new Ring Doorbell, you can attach the included wire extenders using the included wire nuts.
Page 7
Mount your Ring Doorbell It may take a moment for your with the two included Ring Doorbell to power on. mounting screws. You’ll know it’s ready once it lights up and speaks to you. Be sure to feed any excess wiring back into the wall first.
Page 8
Ring Doorbell. to drive the small security screw into the bottom of Search for “Ring” in one of the your Ring Doorbell. app stores below, or visit ring.com/app DO NOT USE...
Page 9
How much does it cost? Ring Protect Basic covers one Ring device for $3 USD/ month or $30 USD/year.* Ring Protect Plus covers all Ring devices at one property, and costs $10 USD/month or $100 USD/year.**...
Quick Start 1. Open the Ring app and select Set Up Device. Then follow the in-app instructions. 2. Scan this code. This identifies your Ring device to make setup fast and easy. QR+FR For additional help, visit ring.com/help...
Important Product Information Ring_INBOX_WSL_GrahamCracker_DoorbellWired_EN_v2d_GH Ring_INBOX_WSL_GrahamCracker_DoorbellWired_EN_v2d_GH 11/10/20 12:14 PM 11/10/20 12:14 PM...
Page 15
Your device can withstand outdoor use and has been tested to withstand water projected If you install the Ring Video Doorbell Wired where through a 6.3mm nozzle at a volume of 12.5 liters a doorbell is already in use and you connect the per minute and a pressure of 30 kPa at a distance Ring Video Doorbell Wired to your home’s door-...
Page 16
For information about The party responsible for FCC compliance is: recycling your device, go to www.amazon.com/ Ring LLC, 1523 26th St, Santa Monica, CA USA, devicesupport. 90404 Terms of Service and Warranty...
Need help?
Do you have a question about the BHAGC001 and is the answer not in the manual?
Questions and answers