Baby Lock BL-6800 Service Manual page 12

5. (BL6800)
Remove the three screws holding the PC board assembly on the rear of the sewing machine, remove the
PC board assembly, and then remove the three wiring harness bands for the lamp cord.
(BL6300)
Remove the two screws holding the 3-pin socket folder assembly on the rear of the sewing machine,
remove the 3-pin socket folder, and then remove the three wiring harness bands for the lamp cord.
6. Remove the screws holding the cord clamp.
7. Remove the two screws holding the motor holder, then remove the motor. The driving belt can be removed
too.
Disassembly Point (BL6800 only)
* When removing a lead connector, hold it by the connector shell.
Pulling on the lead wire (instead of the connector shell) can damage it.
(BL6800)
(BL6300)
Lamp cord
Lamp cord
-10-