Polaris SCRAMBLER XP 1000 S 2020 Owner's Manual For Maintenance And Safety page 53

DIAGNOSTIC CODE
Diagnostic Code Screen will show available MIL that has come on during that
1. Press and hold the MODE button to enter the Options Menu.
"OPTIONS" will display on the screen for 3 seconds before showing first menu
2. Select "Diagnostic Codes" from the Options Menu by pressing the MODE
button.
Toggle the Up/Down Buttons to cycle through Code(s).
This option will only be available if a fault code was set or is active during the
current ignition key 'on' cycle. Turning off the ignition will clear any save fault
Reference the image shown above:
q
w
e
3. To exit the Options Menu the user can select Exit Menu function from
Options Menu, can hold Mode Button and exit out of Options Menu, or not
press any button for 10 seconds, which will exit out of the Options Menu.
DIAGNOSTIC DISPLAY CODE DEFINITIONS
Open Load:There is a break in the wires that lead to the item listed in the chart
(injector, fuel pump, etc.), or the item has failed.
Short-to-Ground:The wire is shorted to ground between the electronic control
unit and the item listed in the chart.
Downloaded from ManualsNet.com
Area A will Display FMI (XX)
Area B will Display SPN (XXXXXX)
Clock Area will Display Count (XXX)
search engine
FEATURES AND CONTROLS
NOTICE
ignition cycle.
NOTICE
item.
NOTICE
codes from the gauge.
51