Bosch Professional GSZ 160 Original Instructions Manual page 6

OBJ_BUCH-536-002.book Page 6 Tuesday, November 24, 2009 1:24 PM
6 | English
Product Features
The numbering of the product features refers to
the illustration of the machine on the graphics
page.
1 Blade
2 Cutter bars
3 Screws for cutter bar
4 Blade bolts
5 On/Off switch
Accessories shown or described are not part of the
standard delivery scope of the product. A complete
overview of accessories can be found in our acces-
sories program.
Technical Data
Slot Shear
Article number
Rated power input
Output power
Stroke rate at no load
n
0
Stroke speed under
load
Cutting speed
Max. steel sheet cut-
1) 2)
ting capacity
Smallest curve radius
with blade for:
– Straight cut
– Curved cut
Weight according to
EPTA-Procedure
01/2003
Protection class
2
1) to 400 N/mm with reference to steel sheet
2) with blade for straight cut
The values given are valid for nominal voltages [U] of
230/240 V. For lower voltage and models for specific
countries, these values can vary.
Please observe the article number on the type plate of
your machine. The trade names of the individual ma-
chines may vary.
1 609 929 M56 | (24.11.09)
Assembly
Replacing the blade (see figure A)
Special blades are available for straight cuts and
curved cuts (accessory).
Press out the bolt 4 to the right or to the left in
order to remove the blade 1. Pull the blade 1 out
of the tool holder.
Slightly lubricate the bolt 4 and the blade to be
mounted 1.
Push the blade 1 into the tool holder so that the
borehole of the blade and of the tool holder cor-
respond to each other.
Push the bolt 4 through the boreholes until you
GSZ 160
can hear it snapping in.
Professional
0 601 521 0..
Operation
W 500
W 270
Starting Operation
-1
min 5600
-1
min 3600
m/min 6–10
Switching On and Off
mm 1.6
To start the machine, push the On/Off switch 5
forwards.
mm 90
To lock the On/Off switch 5, additionally push
mm 30
down the front of the switch.
To switch off the machine, release the On/Off
switch 5. When the On/Off switch is locked, press
kg 1.6
on the rear of the switch and then release it.
/ II
Before any work on the machine itself, pull
the mains plug.
Observe correct mains voltage! The voltage
of the power source must agree with the
voltage specified on the nameplate of the
machine. Power tools marked with 230 V
can also be operated with 220 V.
Bosch Power Tools