Using The Mounting Template; Wall-Mounting The Product - Vaillant ecoTEC plus VU 446/5-5 (H-GB) Installation And Maintenance Instructions Manual

6.7.3 Flue Configuration Description
6.7.3.1 Horizontal Concentric Flue ⌀ 80/125 mm (C13
type installation)
1
1 Gasket (fitted)
Note
If the terminal is at less than 1.80 m from the
ground, you must install a terminal protection kit.
Consult the separate installation manual for air/flue gas sys-
tems supplied with your appliance for all possibilities and as-
sociated accessories and how to install the flue system.
6.7.3.2 Terminal protection
Validity: Great Britain OR Ireland
A terminal guard is required if persons could come into con-
tact with the terminal or the terminal could be subject to dam-
age.
If a terminal guard is required, it must be positioned to
provide minimum of 50 mm clearance from any part of the
terminal and be central over the terminal.
The guard should be similar to that shown in the figure.
0020261389_03 ecoTEC plus Installation and maintenance instructions
6.7.3.3 Vertical Concentric Flue ⌀ 80/125 mm (C33
type installation)
Consult the separate installation manual for air/flue gas sys-
tems supplied with your appliance for all possibilities and as-
sociated accessories and how to install the flue system.
6.8

Using the mounting template

▶
Use the mounting template to ascertain the locations at
which you need to drill holes and make breakthroughs.
6.9

Wall-mounting the product

1. Check the load-bearing capacity of the wall.
2. Note the total weight of the product.
3. Only use fixing material that is permitted for the wall.
4. If required, ensure that mounting apparatus on-site has
sufficient load-bearing capacity.
5. Wall-mount the product as described.
17