Table of Contents
Advertisement
Starting the Drystar Kiosk
1. Make sure that the power cord is connected to the mains power supply and
to the power cable socket at the rear side of the device and that the power
on/off switch at the rear side of the device is switched on.
1
Power cable socket with mains power on/off switch
1.
Power on button (rear side of top door)
2.
Figure 7: Rear view
2. Press and hold the power on button for 3 seconds.
The software is started.
The printers are started.
It may take a couple of minutes for the printers to start up. While the
printers are starting up, a progress bar is displayed.
After startup the display shows the available paper and film in the printer
trays. The display shows the animation to instruct the patient to scan a
barcode.
1
2 3
Drystar Kiosk Operator Manual | Operation | 31
4
2
0401B EN 20211008 1002
Advertisement
Table of Contents
