Dell Latitude 9330 Service Manual page 61

Table 7. System setup options—Storage menu
Storage
SATA Operation
Storage Interface
Port Enablement
Drive Information
Enable SMART Reporting
Table 8. System setup options—Display menu
Display
Display Brightness
Brightness on battery power
Brightness on AC power
Touch Screen
Full Screen Logo
Table 9. System setup options—Connection menu
Connection
Wireless Device Enable
Enable UEFI Network Stack
Enable UEFI Network Stack
Wireless Radio Control
Configures operating mode of the integrated SATA hard drive controller.
Default: RAID On. SATA is configured to support RAID (Intel Rapid Restore
Technology).
Enables the selected onboard drives.
● SATA-4
Default: ON
● M.2 PCIe SSD-0
Default: ON
● M.2 PCIe SSD-1
Default: ON
Displays the information of various onboard drives.
Enables or disables Self-Monitoring, Analysis, and Reporting Technology
(SMART).
Default: OFF
Sets the screen brightness when the computer is running on battery power.
Default: 50
Sets the screen brightness when the computer is running on AC power.
Default: 100
Enables or disables the touch screen for the OS.
NOTE: The touch screen will always work in the BIOS setup irrespective of
this setting.
Enabled or disabled the computer to display full screen logo if the image match
screen resolution.
Default: OFF
Enable or disable internal WLAN/Bluetooth devices.
By default, WLAN is selected.
By default, Bluetooth is selected.
When enabled, UEFI networking protocols are installed and available, allowing
pre-OS and early OS networking features to use any enabled NICs. This may be
used without PXE turned on.
Default: ON
BIOS setup 61