Sidestand - Yamaha Tenere 700 2021 Owner's Manual

1
1. Power outlet
5. Turn the vehicle power on, and
start the engine.
6. Turn the accessory on.
TIP
When finished riding, be sure to turn off
the accessory, disconnect it, then in-
stall the power outlet cap.
WARNING
To prevent electrical shock or short-
circuiting, make sure that the cap is
installed when the power outlet is
not being used.
Auxiliary DC connectors
This vehicle is equipped with an auxil-
iary DC connector, a grip warmer DC
connector and a fog lamps connector.
Consult a Yamaha dealer before in-
stalling any accessories.
EWA21220
Instrument and control functions

Sidestand

The sidestand is located on the left
side of the frame. Raise the sidestand
or lower it with your foot while holding
the vehicle upright.
TIP
The built-in sidestand switch is part of
the ignition circuit cut-off system,
which cuts the ignition in certain situa-
tions. (See the following section for an
explanation of the ignition circuit cut-
off system.)
The vehicle must not be ridden with
the sidestand down, or if the side-
stand cannot be properly moved up
(or does not stay up), otherwise the
sidestand could contact the ground
and distract the operator, resulting
in a possible loss of control.
Yamaha's ignition circuit cut-off
system has been designed to assist
the operator in fulfilling the respon-
sibility of raising the sidestand be-
fore starting off. Therefore, check
4-25
WARNING
EAU15306
4
EWA10242