Zanussi ZWG580E User Manual page 11

STARTING A PROGRAMME WITHOUT THE
DELAY START
Press the button
• The indicator of the button
flash and stays on.
• The programme starts, the door locks, the
indicator is on.
The drain pump can operate for a
short time at the beginning of the
washing cycle.
STARTING A PROGRAMME WITH THE DELAY
START
The start of the programme can be delayed by 9, 6
or 3 hours.
1. Press the button Delay Start to choose the
delay you want to set.
The indicator of the selected delay comes on.
2. Press the button
• The appliance starts the countdown.
• When the countdown is completed, the
programme starts automatically.
You can cancel or change the set of
the delay start before you press the
button . After pressing the button
you can only cancel the delay.
To cancel the delay start:
1. Press the button
pause.
2. Press the button Delay Start until the indicator
of the set delay goes off.
Press the button
programme immediately.
INTERRUPTING A PROGRAMME AND
CHANGING THE OPTIONS
You can change only some options before they
operate.
1. Press .
The indicator flashes.
2. Change the options.
3. Press again.
The programme continues.
CANCELLING A RUNNING PROGRAMME
1. Turn the programme knob to position
cancel the programme and to deactivate the
appliance.
.
stops to
:
to set the appliance to
again to start the
2. Turn the programme knob again to activate the
appliance. Now, you can set a new washing
programme.
Before starting the new programme
the appliance could drain the water. in
this case, make sure that the detergent
is still in the detergent compartment, if
not fill the detergent again.
OPENING THE DOOR WHEN THE DELAY
START OPERATES
While the delay start operates, the appliance door
is locked and the indicator
1. Press
2. Wait until the door lock indicator
3. Open the door.
4. Close the door.
5. Press
The delay start continues to operate.
OPENING THE DOOR WHEN THE
PROGRAMME OPERATES
While the programme operates, the appliance door
is locked and the indicator
CAUTION! If the temperature and
level of the water in the drum are too
high, you cannot open the door.
1. Turn the programme knob to position
deactivate the appliance.
2. Wait some minutes until the indicator
off and then open carefully the appliance door.
3. Close the appliance door.
4. Set the programme again.
AT THE END OF THE PROGRAMME
• The appliance stops automatically.
• The indicator of the
• The door lock indicator
go off. The indicator
• You can open the door.
• Remove the laundry from the appliance. Make
sure that the drum is empty.
• Close the water tap.
• Turn the programme knob to the position
deactivate the appliance.
• Keep the door ajar, to prevent the mildew and
odours.
The washing programme is completed, but
to
there is water in the drum:
is on.
to pause the appliance.
again.
is on.
goes off.
and the indicator
goes on.
goes off.
to
goes
to
11