Download
Share
Print this page
Stanley 204018 Quick Reference Manual
  1. Manuals
  2. Brands
  3. Stanley Manuals
  4. Tools
  5. 204018
  6. Quick reference manual
Stanley 204018 Quick Reference Manual

Stanley 204018 Quick Reference Manual

Panic hardware exit device
Hide thumbs
1
2
3
4
5
6

Advertisement

Quick Links

Download this manual
Stanley Access Technologies
Quick-Reference Guide
Prohibition on Copying
Any unauthorized reproduction, disclosure or distribution of copies by any person
of any portion of this work may be a violation of copyright law of the United
States of America and other countries, could result in the awarding of statutory
damages of up to $250,000 (17 USC 504) for infringement, and may result in
further civil and criminal penalties. All rights reserved.
Filename: "Panic Hardware Exit Device Installation"
Location:
Issued By: PCN 04-132
Revised By: M. Sheehan
Panic Hardware Exit Device
Installation Manual
Quick-Reference Guide
204018
Rev. A, 12-3-04
Page 1 of 6
Date Created: 8/16/2004
Date Revised: 12/3/2004

Advertisement

loading

Related Manuals for Stanley 204018

Summary of Contents for Stanley 204018

  • Page 1 Stanley Access Technologies Quick-Reference Guide Panic Hardware Exit Device Installation Manual Quick-Reference Guide 204018 Rev. A, 12-3-04 Prohibition on Copying Any unauthorized reproduction, disclosure or distribution of copies by any person of any portion of this work may be a violation of copyright law of the United...
  • Page 2 1. Lay SX panel horizontally with escutcheon and cylinder lock facing down. 2. Install screw #6-32 x 2” into the center block to aid in pulling and holding the center block in position. 3. Remove Dummy Plate from center block. Be sure to save the two #10- 32 x 3/4”...
  • Page 3 7. Secure Crank arm. a. Remove the #6-32 x 2” helper screw. b. Align crank arm with shaft. You may have to operate the push bar scissors to align tab with slot. c. Secure with one #6-32 x 1/4” truss head. (See Fig. 7) 8.
  • Page 4 10. Insert cover strip into back bar. Push in until flush with back bar extension. (See Fig. 11) 11. Install base caps and secure with four #10-32 x 2” self-tapping screws. (See Fig.12) Filename: “Panic Hardware Exit Device Installation” Location: Date Created: 8/16/2004 Issued By: PCN 04-132 Date Revised: 12/3/2004...

  • Page 5: Mounting Screws

    12. Adjust bottom throw bolt length. a. Remove the four #10-32 flat head screws from the guide block in the bottom of the stile b. Rotate the bottom throw bolt counterclockwise until it sticks out 5/8” from the bottom of the stile. c.
  • Page 6 c. Push the jamb sensor in and you should see about 5/8” of movement from the top bolt. Filename: “Panic Hardware Exit Device Installation” Location: Date Created: 8/16/2004 Issued By: PCN 04-132 Date Revised: 12/3/2004 Revised By: M. Sheehan Page 6 of 6...