Table of Contents
Advertisement
Quick Links
G FLOW, G FLOW PULSI,
G FLOW REED
ITALIANO
IT
(lingua originale)
ENGLISH
EN
(translation of original instructions)
Adam Pumps S.p.A.
Soc. con Socio Unico
UM021
via della resistenza 46/48 - 41011 Campogalliano (MO) ITALIA
7/2020 - rev. 5
Tel +39 059 528128 - Fax +39 059 528437
www.adampumps.com - info@adampumps.com
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Adam Pumps G FLOW
Summary of Contents for Adam Pumps G FLOW
- Page 1 G FLOW, G FLOW PULSI, G FLOW REED ITALIANO (lingua originale) ENGLISH (translation of original instructions) Adam Pumps S.p.A. Soc. con Socio Unico UM021 via della resistenza 46/48 - 41011 Campogalliano (MO) ITALIA 7/2020 - rev. 5 Tel +39 059 528128 - Fax +39 059 528437...
-
Page 2: Table Of Contents
Directive 2014/30/EU of the European Parliament and of the Council of 26 February 2014 on the harmonisation of the laws of the Member States relating to electromagnetic compatibility. The documentation is available to the relevant authority, against a justified request, from ADAM PUMPS S.p.a. or by sending a request to: info@adampumps.com The person authorised to compile the technical file and draw up the declaration is Davide Stassi as legal representative. -
Page 3: General Warnings
Reproduction rights: This manual is the property of ADAM PUMPS S.p.A., which is the sole owner of all rights provided for by applicable law, including without limitation copyright rules. All rights under these rules belong to ADAM PUMPS S.p.A.: reproduction, even partial, of this manual, its publication, modification, transcription, public... -
Page 4: Packaging
Personal Protective Equipment to be worn: Safety footwear Protective clothing Protective gloves Safety goggles 2.4 Packaging G-FLOW is supplied in a box bearing a label with the following data: - Product - Product version - Gross weight - Flow direction of the fluid (Up, Down, Right, Left) 2.5 Contents Open the package with a pair of scissors or a cutter. -
Page 5: Installation
4 - INSTALLATION 4.1 General installation The G-FLOW meter has 1” or 3/4” threaded inlets and outlets, depending on the fluid with which it has been calibrated. The meter is designed for fixed installation on a line. Important:Do not use conical connections that can damage the body of the meter or the connection flange. -
Page 6: Partial
5.2 “PARTIAL” screen Displaying 4.2 digits, it is accessed with the meter off and by pressing any key or by starting dispensing. With the meter on and with any screen displayed, simply wait 10 seconds without pressing any key to display the partial. -
Page 7: Instant Flow Rate
65000 litres. This number identifies the minimum amount of liquid in the storage tank, below which the flow meter signals a Stock alert. To set this stock, go to the “Alert” screen and press The value displayed will start flashing and can then be changed as required by pressing to increase it or to decrease it. -
Page 8: Selecting The Unit Of Measurement
that the flow rate per minute is more than 10 litres and that, while dispensing, it is not topped up as cali- bration would be inaccurate. Fully open the nozzle. If the amount displayed does not match the measured quantity, the meter must be calibrated. Press to enter Calibration mode where the word “CAL”... -
Page 9: Troubleshooting
7 - TROUBLESHOOTING 7.1 Maintenance troubleshooting table Problems: Possible causes: Solutions: The meter does not read Filter is clogged Clean the filter Meter placed incorrectly Check the direction arrow of the liquid on the flow Electronic problem meter body; if the meter has been installed upside down it won’t work Contact the dealer, specifying the error code GF00 The display is not switching on... -
Page 10: Demolition And Disposal
Adam Pumps. The goods can be returned only if provided with an authorisa- tion code. Upon request, Adam Pumps will provide this code which will invoke the warranty for the product to be repaired or... -
Page 11: Technical Support
The warranty will not be applied in the following cases Failure to use or install the product according to Adam Pumps' instructions The product has been used with unauthorised fluids. The product has been modified or tampered with The product is used in an area with power supply defects (voltage changes, current phase shift, etc.) The product is used without the supplied suction filter (inside or outside the pump). - Page 12 SPECIFICATIONS DISPLAY PULSES REED SWITCH Measuring system: Oval gears Oval gears Oval gears Degree of protection: IP55 IP55 IP55 Power supply: 2 x 1.5V AAA 12V DC - 10 mA (yellow max 200 Vdc 0.5 A; max 140 +12V, brown 0V) Vac 0.35 A Pulse signal [pul/out]: (**)
- Page 13 V.Perrotta Data Data Firma 02/12/2015 02/12/2015 - Componente Adam Pumps - Materiale Denominazione Codice Proprietà della ADAM PUMPS Spa - Senza autorizz costruzione dell' oggetto rappresentato, nè venire com CODE DESCRIPTION CODE DESCRIPTION DISPLAY PULSE OUT DISPLAY PULSE OUT TF066A...
- Page 14 Num. articolo G FLOW REED SWITCH Tolleranze generali UNI EN 22768- Disegnato V.Perrotta Data 02/12/2015 - Componente CODE DESCRIPTION CODE DESCRIPTION TF066A Body TF076 Inlet filter Proprietà della A costruzione dell' o TF065A Cover TF072 Cover plate TF064 Inlet flange...
Need help?
Do you have a question about the G FLOW and is the answer not in the manual?
Questions and answers