Never Use A Stabilizer Or Printable Discs; Beware Of Condensation; Use Of The Remote Control Unit; Batteries - Tascam Professional CD-RW900 Owner's Manual

Never use a stabilizer or printable discs

Using commercially available CD stabilizers or
printable recordable discs with this player will dam-
age the mechanism and cause it to malfunction.

Beware of condensation

If the unit (or a compact disc) is moved from a cold
to a warm place, or used after a sudden temperature
change, there is a danger of condensation; vapor in
the air could condense on the internal mechanism,

Use of the remote control unit

≠ Do not expose the infra-red receiver (light
receptive area on the front panel) to direct
sunlight or intense light for extended periods of
time. Long exposure to this light may result in
failure of the remote control sensor.
≠ When the remote control will not be used over
one month, please remove the batteries to
prevent the possibility of battery acid leakage
which could damage the unit. Should leakage
occur, remove and discard the batteries, and
wipe the battery case thoroughly with a cloth.
Avoid getting the battery liquid on the skin. After
cleaning, replace with new batteries.

Batteries

If batteries are used improperly, or if leakage or
breakage occurs, the unit will not function.
Please observe the cautions indicated on the batteries
and their packaging to ensure proper usage.
≠ Co nfi rm + an d − p olari ty a nd fol low t h e
indications when inserting new batteries into the
remote control.
≠ Do not use old and new batteries together.
≠ Even if the battery is the same size, the voltage
may differ. Do not use batteries of different
specifications together.
≠ Do not attempt to recharge batteries that are non-re-
chargeable.

Connections

The following should be noted when you connect the
unit to other equipment.
It is possible to connect the unit's
AXIAL IN, DIGITAL OPTICAL IN
UNBALANCED INs (L, R)
same time. However, the unit can receive signals
from only one digital input at a time.
Currently selected input jack is shown on the display.
DIGITAL CO -
and
ANALOG
to other equipment at the
1 − Introduction
1-Introduction
NOTE
Never use a disc that has had a stabilizer mounted
to it. The residual adhesive may cause the disc to
stick to the turntable of the CD-RW900. If it sticks to
the turntable, you will need a technician to get it out.
making correct operation impossible. To prevent
this, or if this occurs, leave the player for one or two
hours with the power turned on, then turn the power
off and on again.
≠ The remote control functions by using an infrared
light signal. When using the unit to control the
CD-RW900, other devices that are turned on
could be operated by its signal.
≠ If the range of remote operation becomes smaller,
or commands do not always function properly,
the batteries have become weak and should be
replaced. Always replace both batteries with new
batteries of the same type.
≠ Point the remote control to the remote sensor on
the main unit. Do not obstruct the path between
the remote control and the remote sensor.
Do not open or disassemble batteries, throw them
≠
into a fire or put them in water.

Inserting batteries

1. Open the lid.
2. Confirm +/- polarity, and insert two AAA batteries.
3. Close the lid.
Audio signals output from the unit are output from
the analog
ANALOG OUT
DIGITAL COAXIAL OUT
CAL OUT connector simultaneously (but not from the
digital outputs in stop mode).
jacks, as well as from the
jack and
DIGITAL OPTI -

TASCAM CD-RW900