Table of Contents
Advertisement
8 – Reference and specifications
1 – Introduction
Error messages
Message
Cannot Rec!
Disc Error!
Disc Full !!
Drive Error!
D-IN UNLOCK!
Cannot ERASE!
Erase Error!
Not Fs 44.1k!
PGM Full !
Rec Error
System Err!
Eject Error!
Messages displayed during normal operation
Message
Complete
Now OPC
Now REPAIR
PMA Writing
TOC Reading
REC Standby
Blank Disc
NO DISC
34
TASCAM CC-222SL
MK
8 – Reference and specifications
Details / Response
Use unfinalized recordable disc.
The unit may ejects the loaded disc. If it is CD-RW disc, you may refresh it
("Refreshing a disc" on page 29), or replace disc.
There is no space on disc, or no tracks are available.
There is problem with the Drive mechanism.
Digital input is not connected. Turn on power of source unit and
connect to DIGITAL IN.
The data cannot be erased.
An error has occurred while trying to erase disc.
The sampling frequency of digital input is not 44.1kHz.
Please turn SRC on ("Frequency conversion" on page 21).
An attempt has been made to create more than 99 tracks.
A general recording error. Try recording again with different disc.
The unit may ejects the loaded disc.
System Error. Try turning the power off and on again.
There is a problem with the disc slot.
Statement
An operation such as finalize or erase has been successfully completed.
Calibration is being performed to operate recording properly.
The disc is being repaired and this operation will take a long time.
Please do not turn off power of the unit until it finishes.
Recorded content is being written to disc.
Table of contents data is being read.
The unit is in recording standby mode.
A blank recordable disc has been inserted.
A disc is not loaded into the unit.
II
Advertisement
Table of Contents
