Metro DataVac STARSYS Manual page 3

c. Press and hold the Enter button
d. Press and release the 8 button
e. Release the Enter button
f. A confirmation tune will play
g. If an entry is out of range or incorrect, a warning chirp will play
4. To turn OFF the Auto Relock Warning beeper:
a. Access the cart with a supervisor credential (default supervisor code is 1350)
b. Press and hold the Enter button
c. Press and release the 7 button
d. Release the Enter button
e. A confirmation tune will play
5. At any point when the cart is open, pressing any key (except LOCK/CLEAR) will reset the Auto Relock timer
NOTE: If the value entered for either the relock timer or the auto relock warning is more than the maximum set point, then the
maximum allowable value will be taken by default.
Section 5: SETUP Mode
SETUP MODE:
Set up Mode would be necessary only:
1. In the event that initialization of the electronic lock was done via manual programming and it is now desired to add the electronic
lock to the database in LockView.
2. In lieu of a valid Supervisor credential, set up mode allows manual programming of Supervisor and/or User credentials.
To place the electronic lock into SETUP mode:
1. Press LOCK/CLEAR for 3 seconds.
2. Enter the 8 digit setup code (Setup Cd) assigned to the electronic lock and press ENTER. (See green sticker set for setup code.)
NOTE: Each electronic lock has a unique setup code.
3. Press LOCK/CLEAR to exit setup mode.
Section 6: Battery Installation
1. Cart shipped without batteries installed for electronic locking.
2. Batteries located in top (Non Controlled Substance) drawer of cart.
3. Follow Below steps for battery installation.(The cart shown in the below images is for reference)
1
Battery Tray
BASIC ELECTRONIC LOCK — MANUAL PROGRAMMING GUIDE
2
Pull Down Latch
Hinge Pins On
Both Sides
3
www.metro.com
3
Pull out
Battery
Tray
L01-637
REV B 10/21