Panta Rhei Hydro Wizard ECM 42 Operating Manual page 15

Operating manual
• During operation, the pump must be completely
immersed into water. The drive should be
assembled in such a depth below the water
surface that no air is sucked in from the surface
during operation. Please pay attention that the
height of the water level is changing during
wave simulation.
• The drive can be directly assembled via a solid
ground in the tank. In case of a sandy ground, a
vacuum effect may be the result. In order to
avoid that, increase the distance to the ground.
Objects sucked in may emerge from the flow
conditioner at high speed and cause damage.
• It must be ensured that the intake basket is not
covered by plants and similar objects.
• The cable must be protected against animals
which are able to damage the cable.
• It is advisable to remove, from the inside, algae
and biofilms from the aquarium pane on the
point, where the Hydro Wizard
in order to ensure better grip.
• By loosening the cylinder screw on the
magnetic base, the angle adjustment of the
Hydro Wizard
subsequently be fixed again.
®
can be changed and
10
Hydro Wizard
®
is to attached,
®
ECM 42