Replacing Clutch Parts; Installing Clutch Assembly - Echo CS-310 Service Manual

40

5-2 Replacing clutch parts

B

5-3 Installing clutch assembly

A
a
B
C
CLUTCH SYSTEM
A
C
a
D
c
E
1. Install clutch spring (A) to clutch shoes (B).
2. Set one arm of clutch hub (C) to one clutch
shoe.
3. Install other two clutch shoes on two arms as
shown.
1. Install worm gear (A).
2. Install clutch plate (B), facing rounded edge side
to worm gear.
3. Install clutch plate (C), facing the side with
punch mark "UP" (c) to outside.
4. Install clutch assembly (D; Left-hand thread) to
crankshaft turning counterclockwise by hand until it
can not be turned further.
NOTE: If starter assembly is installed, untie tempo-
rary knot holding starter grip (tied in the fi rst NOTE
of "5-1 Inspecting clutch parts"). While holding
starter grip, turn clutch assembly counterclockwise
until it cannot rotate further (piston touches piston
stopper).
5. Tighten clutch assembly with clutch tool
897505-16133 (E).
CS-310