Related Manuals for Atlas DAGNY
Summary of Contents for Atlas DAGNY
- Page 1 DAGNY Ceiling Mounted Rotational Fan READ AND SAVE THESE INSTRUCTIONS FAN RATING AC 110V-60Hz...
-
Page 2: Tools And Materials Required
TOOLS AND MATERIALS REQUIRED • Philips screw driver \\\1\' • Standard, flat-head screw driver • 11 mm wrench • Step ladder • Wire cutters PACKAGE CONTENTS t !~:iE~S). {Q~I: Unpack your fan and check the contents. You should have the following items: Hanger bracket assembly ~e-ii Ball... - Page 3 READ AND SAVE THESE SAFETY AND INSTAllATION INSTRUCTIONS. Consult a licensed electrician if unsure of any point below mentioned. DANGERIWARNING/CAUTION 1. Hi9.hvoltage and. moving parts around motors and motor driven equipment can cause senous or fatal InJunes. Always disconnect power source at main switch before wiring, servicing or cleaning unit.
- Page 4 11. To reduce the risk of personal injury, install the supplementary mounting means and use only the hardware provided with the fan. 12. Warning: TO REDUCE THE RISKS OF FIRE, ELECTRIC SHOCK OR INJURY TO PERSONS, OBSERVE THE FOllOWING: A. Use this unit only in the manner intended by the manufacturer. If you have any questions, contact the manufacturer.
- Page 5 MOU NTING/INSTALLATION ~:~~~~ OF THE FAN bracket ~ \_. J"-;:~I~~~ Before touching a screw driver thoroughly read these instructions. • • Warning/Caution: Before installing fan, turn off .•l..--Canopy power at service panel and check all visible cover Figure 5 screws and bolts for tightness. 1.
- Page 6 Bolts to attach Screw cages are in the hardware pack, 'i'. The Atlas medallion should be oriented correctly. Handle your blades carefully otherwise you will bend the blade irons and cause your fan to vibrate Safety cable when in use.
-
Page 7: Making The Electrical Connections
GROUND-(3 GROUND WIRES wire connections with the plastic wire nuts (GREEN) ON CEILING FAN) provided. Dagny has no light, so the blue receiver "light" wire must be capped off to avoid electrical shock. (Fig. 12) WHITE (NEUTRAL) BLACK (MOTOR) Note: Fan must be installed from a maximum... - Page 8 4. If your outlet box has a GROUND wire (Green or Bare Copper) connect this wire to the Hanger Ball and Hanger Bracket Ground bOX--.[ wires. If your outlet box does not have a Outlet Ground Wire, then connect the Hanger Ball and Hanger Bracket Ground Wires together.
-
Page 9: Operating The Remote Control
" B. OFF Button: This button turns the fan off. C. ACCESSORY Button: Additional unused accessory circuit. This unused and accessory circuit can be used to operate another light or fan, other than the Dagny, in your room. Figure 15... - Page 10 Be careful that the blade brackets themselves are not bent in this process. Do not operate your fan if it continues to vibrate. Contact your Atlas Fan Co purveyor if the re-installation of the blades does not resolve the problem.
Need help?
Do you have a question about the DAGNY and is the answer not in the manual?
Questions and answers